![]() Large (L): 22+ Table: Loop Counts Value for Numerator and Denominator Left Thumb Denominator Right Thumb Numerator 1 to 11= S (small).In this case, you can use the same values of the left thumb i.e.Ĭase 2: Ridge count of Left thumb is greater than 16įor this, new sets of values are assigned for the right thumb: Large (L): 16+ Loop Count Values for the Right ThumbĬase 1: Ridge count of the left thumb is 16 or less.6 fingers) has only one set of values for loops. That’s the reason why you should first come up with the values of the loop of the left thumb (number 6 finger). And the right thumb value system is chosen based on the ridge count of the left thumb finger. This is because, for the right thumb finger, there are two value sets. While evaluating loops value, you should first count the loops in the left thumb followed by the right thumb. The values of loop counts are represented by small (S), medium (M), or large (L). To evaluate the value of major classification, ridge counting and ridge tracing are performed for loops and whorls, respectively. Values of Major Division Classification System Small Letter Grouping: In case, small letter grouping is present with secondary division values, both sub secondary, and major division are omitted. Arches: When plain and tented arches are on thumb fingers, major classification is not used.Ģ. ![]() For whorl patterns, ridge tracing is considered.ġ.If the pattern is a loop, ridge counting is obtained.Values: Ridge tracing and Ridge counting.Position: placed immediately to the left of the primary classification column.Numerator: Right thumb value (finger 1).Related Questions Rules for Major Classification System.Practical Worksheet for Finding Major Division Number.Major Classification for Scarred and Amputated Fingers.Procedure For Major Division Classification.Values of Major Division Classification System.
0 Comments
Leave a Reply. |